Wet electric mist eliminator spray system installation matters needing attention

Wet electric mist eliminator spray system is one of the important equipment in the industrial process, widely used in gas purification, desulfurization and denitrification and other fields. In order to ensure the normal operation of the system and extend the service life, the installation process requires special attention. The following are some precautions for the installation of the wet electric demister spray system.

1. preparation

1. Before installation, ensure that all parts of the equipment are intact and complete in quantity, and check whether the model and specification meet the design requirements.

2. The construction site should have the necessary installation conditions, such as power supply, water source, lifting equipment, etc.

2. installation points

1. Foundation acceptance: ensure that the installation foundation is flat and firm and meets the equipment requirements.

2. Positioning and leveling: according to the design drawings for equipment positioning, to ensure that the level and verticality to meet the requirements.

3. Pipe connection: The pipe connection of the spray system should be firm and sealed to prevent leakage.

4. spray layer installation: spray layer is the core part, the installation should pay special attention to the position of the nozzle, to ensure uniform spray.

5. Electrical wiring: wiring according to the electrical diagram to ensure that the wiring is correct and firm.

3. Safety Precautions

1. Relevant safety operation regulations shall be observed during installation to prevent accidents.

2. Construction personnel shall wear safety helmet, protective glasses, insulating shoes and other protective equipment.

3. When approaching dangerous areas such as power supply and water source, corresponding safety measures should be taken.

4. commissioning and acceptance

1. After the installation is completed, the system should be debugged to check whether the components are operating normally.

2. During the debugging process, relevant data, such as flow rate, pressure, etc., should be recorded to ensure stable system performance.

3. After debugging is correct, carry out acceptance to ensure that the system meets the design requirements.

Post -5. maintenance

1. After the installation is completed, system inspections should be carried out regularly to ensure the normal operation of the equipment.

2. Regularly clean the nozzle to prevent blockage.

3. Check the electrical part regularly to ensure safety and reliability.

In short, the installation of the wet electric mist eliminator spray system is a complicated process, and it is necessary to strictly abide by the installation procedures to ensure that every step meets the requirements. Only in this way can we ensure the normal operation of the system, improve production efficiency and reduce the risk of accidents.